URG Pro Headlight and Taillight Information

URG Pro Headlight Operation

Check out the video and more detailed instructions below:

 

The URG Pro Headlight is operated using the single button on the top of the light as shown with the arrow above. 

1) Pressing the button when the light is off will turn the light on to its brightest setting
2) Press the button a second time to change it to medium brightness
3) Press the button a third time to turn on the strobe setting
4) Press the button a fourth time to the turn the light off

Please note that there is a battery indicator light built into the button. Indicator light meanings:

Green: battery has sufficient charge
Red: battery charge is getting low

 

Charging your URG Pro Headlight

 

   

 

The USB charging port is located on the back of the light, you can find it by moving the silicone cover out of the USB input as shown above. Simply connect the USB cable and plug the other end into any USB power source to begin charging. 

 

During charging the indicator light inside the button will show red when it is not yet fully charged, this will change to green when it is fully charged.  

 

Mounting your URG Pro Headlight

 

 

 

Slide the strap mount onto the rails below the light as shown above. 

 

           

Wrap the silicone strap around the desired mounting area and buckle the strap into the clip indicated by the arrow above.

 

Taillight Operation 

Check out the video and more detailed instructions below:

 

The taillight is operated using the single button as shown with the arrow above.  

1) Pressing the button when the light is off will turn the light on 
2) Pressing the button when the light is on will cycle through the three levels of brightness
3) To switch between the solid and strobe settings, do a quick double-click of the button
4) Hold down the button for two seconds to switch the light off

NOTE: Again, to switch between strobe and solid light settings just do a quick double-click of the button while the light is on.

Taillight Installation 

The taillight includes a silicone strap that can be used to mount the light to a bicycle or helmet.

To mount the light using the strap, first feed one end of the silicone strap into the clip. Then pull the strap until it sits inside of the groove at the end of the clip as shown above.

Wrap the silicone strap around the desired mounting area and connect the strap to the other end of the clip as shown above.

 

Still have questions? 

As always feel free to reach out to us with any questions, you can drop us a line anytime at info@uncharted-roads.com or use the CONTACT page link at the top of the page.